The PROTECTORGATE range has been designed to complement our full product portfolio of fencing systems.
Single leaf widths
1m, 1.2m, 1.5m, 2m, as well as tailor-made to suit your specific requirements.
Double leaf widths (Between posts)
2m to 10m, as well as tailor-made to suit your specific requirements.
Heights
1.2 metres, 1.5 metres, 1.8 metres, 2 metres, 2.4 metres and 3 metres, as well as
tailor-made to suit your specific requirements.
Gate frames
Can be made from flat bar or rolled steel hollow section
depending on gate size.
Infills
A wide range of infills are available, including round bar,
square bar and hollow sections manufactured to suit our
portfolio of products.
Gate posts
Are either rolled steel hollow section, rolled steel joist, universal beam or universal columns depending on the
site and preference.
Locking methods for general fencing gates are:
- Locinox - can be opened or closed with or without a key.
- Slip latch - that can be padlocked in the open or closed position.
- Traditional pivot latch - when locking is not an issue.
- Anti-climb PROTECTORGATE latch.
PROTECTOR CANTILEVER RANGE
See the DEMO!
The Barkers Fencing PROTECTOR CANTILEVER gate range offers an extensive choice of widths and heights with an almost endless array of infills. Suitable for general applications or high security sites, the PROTECTORGATE Range integrates seamlessly with the complete range of Barkers Fencing perimeter security systems and harmonises with all styles of existing or new boundary installations.
The PROTECTOR CANTILEVER gate range can be operated manually and semi-automatically there is also the option to have a fully automated system installed.
Single leaf widths
Available in widths from 3m to 7m
Double leaf widths
Available in width from 6m to 14m
Heights
1.8m, 2.0m, 2.1m and 2.4m
Manual CANTILEVER gate
The gate is opened and closed by hand, and locked using a euro cylinder type lockinox lock and key.
Dead Man CANTILEVER gate
The gate is powered by an electric three phase motor which operates via a dead mans switch i.e. a key in inserted and turned towards desired directions of movement. Once the hand is removed from the key the gate stops dead.
Automated CANTILEVER gate
Powered by an electric three phase motor, which opens and closes without supervision. This option can be controlled using various access control systems i.e. card swipes, remote control key fobs, ground loops, coded key pads, intercom systems, camera intercom systems, iris readers and finger print readers. The gate opens to allow entry and closes automatically after a pre-set time (e.g. 20 seconds). For safety reasons all automated gates must have safety edges on both the gate leaf end and on the fate support post. An infra-red beam is also required for additional pedestrian and vehicle protection. If at any time during the closing of the gate either the infra-red beam of the safety edges sense an obstruction in the gateway, the gate will stop and re-open, and after a pre-set time re-close.’
